In this paper, we propose a new FPGA design algorithm, Maple-opt, in which technology mapping, placement, and global routing are executed so that the delay of each critical signal path in an input circuit is within a specified upper bound imposed on it. The basic algorithm of Maple-opt is top-down hi-erarchical bi-partitioning of regions. Technology mapping onto logic-blocks of FPGAs, their placement, and global routing are determined simulatenously in each hierarchical process. This simultaneity leads to less congested layout for routing. In addition to that, Maple-opt computes a lower bound of delay for each path with a constraint value and determines critical paths based on the difference between the lower bound and the constraint value dynamically in each hierarchical process. Two delay reduction processes are executed for the critical paths; one is routing delay reduction and the other is logic-block delay reduction. Routing delay reduction is realized such that, when bi-partitioning a region, each constrained path is assigned to one subregion. Logic-block delay reduction is realized such that each constrained path is mapped onto fewer logic-blocks. Experimental results for some benchmark circuits show its efficiency and effectiveness.

Though tree covering is an efficient algorithm for technology mapping, phase assignments on tree boundaries are not taken into consideration. Several inverter minimization algorithms have been proposed so far, but they do phase optimization before or after technology mapping, and their cost function is not to minimize the total area but to minimize the number of inverters. This paper describes a new formulation of phase optimization problem aiming to minimize the total area during the technology mapping. Cost function representing area according to each phase assignment is introduced, and tree covering algorithm is modified to handle that cost function. Edge-Valued Binary Decision Diagram is used to represent the function implicitly. Experimental results show that proposed method reduces about 10% area on average compared with a state-of-the-art logic synthesis system sis.

The paper describes a new algorithm for Boolean matching, which is based on BDD structure manipulation. Pruning of the search space takes place after partial assignments if certain subgraphs of two BDD's become inequivalent. This pruning is different from existing techniques, so that the search space is further reduced. Another feature of this algorithm is topological filtering. Usually, many functions have no matchings and this is easily found by only counting the number of minterms. To check it quickly, upper and lower bounds of minterm count are calculated from topological information. Using these bounds, functions that have no matchings are discarded without building their BDD's.

Technology mapping algorithms for LUT (Look Up Table) based FPGAs have been proposed to transfer a Boolean network into logic-blocks. However, since those algorithms take no layout information into account, they do not always lead to excellent results. In this paper, a simultaneous technology mapping, placement and global routing algorithm for FPGAs, Maple, is presented. Maple is an extended version of a simultaneous placement and global routing algorithm for FPGAs, which is based on recursive partition of layout regions and block sets. Maple inherits its basic process and executes the technology mapping simultaneously in each recursive process. Therefore, the mapping can be done with the placement and global routing information. Experimental results for some benchmark circuits demonstrate its efficiency and effectiveness.